Assembly; Intended Use - Oregon LM300 Manual De Instrucciones

Assembly

Intended Use

The garden product is intended for domestic lawn
mowing
Assembly (Fig. A - B - C - D)
WARNING: Make sure the battery is
removed from the machine.
Fix the rotation-blocks (5) into the lower handle
(3) (Fig. A), then you can fix the lower handle
(3) and the machine together with the knobs (7)
Fix the upper handle to the frame of the lower
handle (Fig. B) and then secure using the knobs
(7), bolts (8), and washer (9) Hand tighten the
Knobs (7)
Assemble the grass box by connecting the two
sides of the box (11, 12) ensuring that all of the
tabs located along the connecting edge of (11)
are properly seated into the edge of (12) You will
hear and audible click sound as each tab is properly
seated Ensure the entire connecting seam between
(11) and (12) is properly connected (Fig. C)
Place the top of the grass box (10) on to the
formed piece of (11) and (12) Ensure that all tabs
on the edge of (11) and (12) properly and securely
seat into the frame of (10) You will hear and
audible click sound as each tab is properly seated
(Fig. C)
Place the grass box handle (6) into the proper
location on the top of the grass box (10) Firmly
push the tabs on the handle into the grass box,
ensuring the handle is properly seated You
will hear and audible click sound as each tab is
properly seated (Fig. C)
To attach the grass box to the machine, lift and
hold the discharge cover with one hand, and
with the opposite hand, slide the grass box onto
the rear of the machine, ensuring that the grass
box properly seats on the frame of the machine
Release the spring loaded discharge cover,
allowing the cover to collapse over the opening
between the grass box and the machine (Fig. D)
Properly secure the cable to the handlebar frame
using the provided cable clips (2) (Fig. D)
Lawn Mower Model LM300
Assembly
Inserting and Removing the Battery
Pack (Fig. E - F - G)
WARNING: Ensure the safety key is turned
off before inserting or removing the battery
pack.
To insert the battery pack, push the button (16)
on the machine battery cover (17) and lift the
cover (17) (Fig. E, F) Insert the battery pack into
the battery cover, ensuring the small rails on the
cover align with the rail slots on the battery pack
Firmly push the battery pack into place, until you
hear an audible click sound Close the battery
cover You will hear an audible click when the
cover is properly closed (Fig. G)
To remove the battery pack, open the battery
cover Lift the small button below the front of
the battery pack to release the battery pack The
spring loaded button will release the battery pack,
allowing you to pull the battery pack out of the
machine Close the cover to prevent accidental
damage to the machine
Adjusting the Cutting Height (Fig. H)
Your lawn mower is equipped with a central height
adjustment system, offering 6 height settings The
setting are approximately 1 in (25 mm), 1 3/8 in
(35 mm), 1 3/4 in (45 mm), 2 1/8 in (55 mm),
2 1/2 in (65 mm), and 3 in (75 mm) The actual
cutting height may vary slightly
To adjust the cutting height of the machine,
position the lever (Fig. H) to the desired height
position The numbers indicated on the body of
the machine (25, 35, 45, 55, 65, 75) indicates the
approximate cutting height of the machine in that
position The lower the number, the shorter the
grass will be cut
Always perform a small test by cutting the
grass at higher settings and adjusting down to
determine your desired cutting height
11