MELICONI CONTROL 2 SIMPLE Instrucciones De Uso página 10

- SETTING CODES USING A MANUAL SEARCH
(only to be performed if the specifi c code could not be found)
CAUTION: the search procedure could take several minutes.
If you want to use the CONTROL 2 Simple to control 2 devices at the same time (TV + DECODER) fi rstly search for
the code for the TV and then for the code for the DECODER. To control just one device, enter only the desired code.
A. Look for the brand of the device that you want to control in the table
at the begging of the booklet, in the column for the type of device, and
make a note of the brand number in the BUTTON column. If the brand is
not present, use "0".
B. Stand in front of the device that you want to control and make sure that
it is ON (not in stand-by). If necessary, switch it on using the original
remote control unit (if this is still working), or the buttons present on
the device itself. (on TVs they can be on the side or the top).
C. Press and hold down the [P +] and [
[P –] for the DECODER) buttons on the MELICONI remote control
simultaneously for 6 seconds).
D. When the indicator light fl ashes, release the buttons and immediately
press the numerical button identifi ed in the table for a moment.
EXAMPLE [6]
E. Point the remote control towards the device that you want to control
and PRESS AND KEEP PRESSED the [
[ STB] for the decoder) on the MELICONI remote control).
CAUTION: you may have to keep the button pressed for a few minutes
before the device switches off.
F. When the device switches off, IMMEDIATELY RELEASE the button and
PRESS [OK]
G. Three fi nal fl ashes indicate that the operation has been completed
successfully.
CHECK - Check that the MELICONI remote control operates your device also with the other main functions; if it
does not, REPEAT the procedure from step B using the same brand number.
If, after various attempts, it still does not work REPEAT the procedure from step B, using 0 (zero) as brand
number.
NOTE: During the search the indicator stops fl ashing and the remote control exits the search mode in the
following cases:
• if for 30 seconds the button indicated is not pressed or if another button is pressed.
• if the list of codes to fi nd is terminated. In this case consult the website, www.meliconi.com, or contact the
technical support.
10
(example TV PHILIPS = 6)
+] to set the TV (or [P +] and
TV] button for the TV part (or
Example TV PHILIPS = 6
4 PANASONIC
5 SHARP
6
PHILIPS
7 TELEFUNKEN
8 MIVAR/UNITED