Inserting The Batteries - MELICONI CONTROL 2 SIMPLE Instrucciones De Uso

I THANK YOU FOR CHOOSING A MELICONI REMOTE CONTROL
EN
The CONTROL 2 Simple remote control is designed to control a TV and a DECODER (satellite or digital terrestrial).
CONTROL 2 Simple is a simplifi ed remote control; it provides ONLY the functions on the keypad.
IMPORTANT!: When the remote control is set to control only the TV, all the buttons will control the TV; whilst when
it is set to control 2 devices (TV + DECODER), only the black buttons will control the TV, whilst the white buttons will
control the DECODER.
The remote control has a permanent memory, so it does not lose its settings even if there are no batteries in it.
SAFETY WARNING: The remote control must not be exposed to excessive heat sources or fi re. The product is not a
toy. Keep out of reach of children or domestic animals.

INSERTING THE BATTERIES

The remote control requires 2 new 1.5V alkaline AAA/LR03 batteries, not included. Insert
them as illustrated. Do NOT use rechargeable batteries.
BATTERIES TEST: KEEP THE ON/OFF [ ] button pressed and check that the indicator light
remains on continuously until the button is released. If the indicator light fl ashes or remains
off, the batteries are not suffi ciently charged. Replace them.
Do not leave fl at batteries inserted, as liquid may leak and damage the remote control.
ACTIVATING THE REMOTE CONTROL
In order to use the remote control it is essential to set a specifi c code for the device that you wish to control.
Use one of the following methods to identify the specifi c code and set it in your remote control:
INTERNET
- SETTING CODES USING INTERNET
www.meliconi.com/guide
Go to the website listed above, or use the qr-code on the side, to access the CODE SEARCH
program. Once you have found the specifi c code for your device, set it in the remote control as
described in the ENTERING THE CODE DIRECTLY section.
ENTERING THE CODE DIRECTLY
(only to be performed if you know the specifi c code to be set)
If you want to use the CONTROL 2 Simple to control 2 devices at the same time (TV + DECODER) set fi rstly the code for
the TV and then the code for the DECODER. To control just one device, enter only the desired code.
- Press and hold down the [P +] and [
for the DECODER) buttons on the MELICONI remote control simultaneously
for 6 seconds).
- When the indicator light fl ashes, release the buttons and immediately
enter the previously identifi ed code (4 numbers).
- Three long fl ashes indicate a correct setting.
If the remote control does NOT fl ash three times, the setting has not been completed. Repeat the procedure. If the
procedure cannot be completed again, it means that the code being set is not in the remote control memory. Contact
technical support
8
KEEP THIS BOOKLET FOR FUTURE REFERENCE
MOBILE PHONE (SMS)
+] to set the TV (or [P +] and [P –]
MANUAL SEARCH