Beurer BM 75 Manual De Instrucciones página 26

Ocultar thumbs Ver también para BM 75:
Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 46
Range of blood pressure values
Grade 3: Severe hypertension
Grade 2: Moderate hypertension
Grade 1: Mild hypertension
High-normal
Normal
Optimal
Source: WHO, 1999
Resting indicator measurement (using HSD diagnostics)
The most frequent error made when measuring blood pressure
is taking the measurement when not at rest (haemodynamic
stability), which means that both the systolic and the diastolic
blood pressures are incorrect in this case.
While measuring the blood pressure, the device automatically
determines whether you are at rest or not.
If there is no indication that the circulatory system is not suf-
ficiently at rest, the symbol
up green and the measurement can be recorded as a reliable
resting blood pressure value.
GREEN: Haemodynamic stability
Measurement of the systolic and diastolic pressure is in-
creased when the circulatory system is sufficiently at rest and
is a very reliable indicator of resting blood pressure.
However, if there is an indication that the circulatory system is
not sufficiently at rest (haemodynamic instability), the symbol
lights up red.
Systolic
(in mmHg)
≥ 180
160 – 179
140 – 159
130 – 139
120 – 129
< 120
(haemodynamic stability) lights
Diastolic
Measure
(in mmHg)
≥ 110
Seek medical advice
100 – 109
Seek medical advice
90 – 99
Have it checked regularly by doctor
85 – 89
Have it checked regularly by doctor
80 – 84
Check it yourself
< 80
Check it yourself
In this case, the measurement should be repeated after a pe-
riod of physical and mental rest. The blood pressure measure-
ment must be taken when the patient is physically and mentally
rested, as it will be the basis for diagnosing the blood pressure
level and regulating the patient's medical treatment.
If the symbol
does not light up green or red, then it could
not be determined whether the circulatory system was suf-
ficiently at rest or not. In this case, the measurement should be
repeated after a period of physical and mental rest.
RED: Lack of haemodynamic stability
It is very probable that the systolic and diastolic blood pressures
have not been measured whilst the patient is at rest and the rest-
ing blood pressure measurement has therefore been distorted.
Repeat the measurement after a rest and relaxation period of
at least five minutes. Go to a sufficiently quiet and comfortable
spot and remain there calmly; close your eyes, breathe deeply
and evenly and try to relax.
If the next measurement also shows insufficient stability, you
can repeat the measurement after another resting period. If the
measurements continue to show some instability, identify these
26

Publicidad

Tabla de contenido
loading

Tabla de contenido