Hilti HIT-ED 3500-A Manual De Instrucciones página 24

7.3 Inserting the holder with foil pack into the
tool 6
NOTE
Foil pack holders are available as accessories.
1. Pull the piston rods back fully while pressing the
release button.
en
2. Grip the foil pack holder by the small cylinder
and insert it into the tool from above, tipping it
slightly to the side before pushing it down into
position.
3. IMPORTANT! The foil pack holder must be in-
serted all the way into the tool. Push the foil pack
holder down slightly to ensure that it is correctly
seated.
7.4 Dispensing 7 8
DANGER
Never point the tool toward yourself or other per-
sons.
CAUTION
The initial quantity dispensed by the first strokes
of the dispenser is unsuitable for use. The quantity
to be discarded is product specific and is indicated
in the applicable instructions for use. The initial
quantity must also be discarded after changing a
mixer.
NOTE
To allow the contents of the first strokes of the
dispenser to be discarded (this initial quantity is
inadequately mixed), the dispenser must be set to
"single stroke".
WARNING! Pull the trigger and hold it in this position
until the dispenser switches itself off. This will ensure
that a full stroke is dispensed.
1. Subsequently, when ready to begin using the
dispenser, set the selector switch to either "single
stroke" or "continuous operation", as desired.
2. Press the trigger to dispense the mortar.
The foil pack is opened automatically by the
piercing system incorporated in the connector.
The two components can be seen to mix as they
pass through the static mixer.
20
Printed: 07.07.2013 | Doc-Nr: PUB / 5069993 / 000 / 00
3. Press the release button after finishing dispens-
ing or if the operation is interrupted.
This relieves the pressure on the foil pack, so no
further mortar escapes from the mixing nozzle.
Mortar in the mixing nozzle hardens if dispensing
is interrupted for a long period.
4. The mixing nozzle must then be changed to allow
use of the mortar remaining in the foil pack.
5. Please refer to the instructions provided with the
foil pack for further information about use of the
product.
7.5 Removing the foil pack 9
NOTE
Store partly-used foil packs in the foil pack holder
with the mixing nozzle screwed on. Partly-used foil
packs have a limited shelf life. Please refer to the
instructions supplied with the foil pack.
NOTE
Foil pack holders are available as accessories.
1. Pull the piston rods back fully while pressing the
release button.
2. Push up the small cylinder through the opening
and then remove the complete foil pack holder.
7.6 Disposing of a foil pack
CAUTION
Dispose of completely emptied foil packs in accord-
ance with the applicable regulations.
The foil pack holder can be reused. When a new foil
pack is inserted into the holder, the built-in pistons
are pushed back into their original position.
7.7 Reading the charge status LED display on
Li ion batteries 10
NOTE
The charge status cannot be indicated while the power
tool is in operation. LED 1 blinks when the battery is
fully discharged or when it is too hot (temperature
above 80°C). The battery must then be inserted in the
charger.