Start-Up; Delivery / Unpacking The Kiln; Disposal Of Packing Material; Installation Environment / Location - Rohde KE L Serie Manual De Instrucciones

Enjoy your results

5. START-UP

5.1. Delivery / Unpacking the kiln

The ROHDE Frontloader will usually be delivered on a pallet by a freight-forwarding agent� Immediately after delivery
check the packaging for any visible damage� Should you detect any damage, unpack the pallet together with the
driver and recheck the goods for damage� Enter details of any damage detected on the delivery note and let the
driver countersign your remarks� Keep one copy of the complaint for your files� Inform the freight-forwarding agency
immediately of the damage� Complaints submitted at a later date cannot be taken into consideration�

5.2. Disposal of packing material

Contribute to a clean environment by disposing of wood, cardboard and plastic packaging material at your nearest
waste disposal plant�
For further information concerning the disposal of packaging material please contact your dealer or community
council�

5.3. Installation environment / Location

When selecting a suitable location for your kiln, please note the following guidelines and prepare the kiln environment
accordingly:
• Place the kiln on an even surface�
• The distance to the walls should be at least 25 cm on each side�
• The floor, ceiling insulation, walls, dividing walls, panelling, etc� must be made of flame resistant material�
• Make sure that the kiln environment can be ventilated properly�
• If this is not the case, a ventilation system must be installed� Please consult a qualified technician specialising in this
field�

5.4. Kiln assembly

figure 1
figure 2
22
Page of 80
Check the enclosed accessories first:
Optional accessory KE-L (100 - 250),
Standard accessory KE-N and KE-S (figure 1):
• 4 cordierite blocks
• 1 exhaust air socket and fixing screws
• 1 panel for mounting the controller and fixing screws
Optional accessory KE 55 -70 L (figure 2):
• 4 small cordierite blocks
• 4 cordierite plates
• 1 chimney brick
• 1 exhaust tube
Status: 01 / 2016