General Operating Instructions; Operating Instructions Controller; Correct Operation During Firing - Rohde KE L Serie Manual De Instrucciones

Enjoy your results

6. GENERAL OPERATING INSTRUCTIONS

6.1. Operating instructions Controller

Please read the kiln control instruction manual carefully� The kiln is ready for operation after it has been connected
to the mains supply and the controller�
Typical firing curves, e.g. with a TC 504 controller
tmp1
t0
Biscuit firing 0�00
Glaze firing 0�00
Please consult your glaze and clay suppliers to find out the firing behaviour of your materials and adapt the firing
curve of your controller accordingly�

6.2. Correct operation during firing

• Do not place flammable objects near the kiln�
• The kiln may only be used in a well-ventilated room� In order to guarantee safe operation, the kiln may be only
operated up to an environmental temperature of 40°C�
• The kiln must be placed in a free-standing position in the room� Make sure that the heat release is not blocked�
Do not place any objects on top of, or around, the kiln�
• Never open the kiln during operation or before it has cooled down completely� High temperatures are released and
might cause physical injury and material damage� The manufacturer of the kiln does not assume any liability in such
cases!
• When firing materials which release hazardous gases and fumes, an exhaust air system must be installed that directs
these into the open air�
• Never use your kiln for firing inflammable materials or food�
26
Page of 80
tmp2
rmp1 t1
100 600
150 300
rmp2
0�10 150
0�05 150
t2 rmp3
950 0�05
1050 0�20
Status: 01 / 2016
SKIP
SKIP