Place The Kiln On Its Legs; Exhaust Air Socket; Exhaust Air Flap - Rohde KE L Serie Manual De Instrucciones

5.5. Place the kiln on its legs

If your Frontloader has not been set up by the ROHDE delivery and set-up service, it is
now time to place the kiln on its legs� Lift the Frontloader using a forklift�
Insert the forks under the kiln door and move them carefully towards the back of the
kiln�
Please make sure that the power cable and AMP socket are not damaged!
Lift the kiln to a position where you can easily mount the legs� Please note that the legs
and mounting positions are marked in red and green� They must be mounted accor-
dingly� Mount the legs on to the kiln with the fi xing screws and lower the kiln into the
position required�

5.6. Exhaust air socket

KE-L series 55 - 70
Place the exhaust tube into the exhaust air opening (fi gure
4) on the kiln ceiling�
Mount the exhaust air socket (optional accessory) into
the holes at the position indicated (fi gure 5a)�
Plug the exhaust air tube (optional accessory) into the
exhaust air socket and use the fi xing screw to fi x it to the
socket�
Open and close the exhaust air opening using the chim-
ney brick (fi gure 5b)�
KE-L series 100 - 250, KE-N and KE-S
Screw the exhaust air socket (fi gure 6) into the hole on
the ceiling of the kiln� The opening has been located in a
position that will allow fumes and gases to be released
through an exhaust air socket (optional accessory)� Plug
the exhaust air tube into the exhaust air socket (fi gure 7)
and use the fi xing screw to fi x it to the socket�
5.7. Exhaust air fl ap
Rohde Frontloaders KE-N and KE-S series are equipped
with an exhaust air handle, operated from front (optional
accessory for KE 100 - 250 L)�
When the handle is pushed in completely (fi gure 8), the
exhaust air opening on the ceiling of the kiln is closed
(fi gure 9)�
To open the exhaust air, pull the handle out completely�
Status: 01 / 2016
fi gure 4
fi gure 6
fi gure 8
fi gure 3
fi gure 5a fi gure 5b
fi gure 7
fi gure 9
23
Page of 80