Rigid R4122 Manual Del Operador página 33

ADJUSTMENTS
TO ADJUST THE MITER LOCK LEVER
See Figures 41 and 42.
In the locked position, the miter lock lever should feel tight
and secure, and considerable effort should be required
to move the miter table. If the miter lock lever feels loose
or the table moves easily when in the locked position, an
adjustment to the miter lock lever is required.
To adjust:
Unplug the saw.
Lift the miter lock lever.
With the unit securely resting on a large stable surface,
tilt the unit by lifting up on one side of the base.
Using the hex head end of the blade wrench, loosen the
two socket head cap screws on the underside of the saw
table.
NOTICE:
To keep from losing control of the unit, steady the
base with one hand while loosening the two socket
head cap screws with the other hand.
Locate the tensioning screw.
Using the philips screwdriver end of the blade wrench,
adjust the tensioning screw until the proper amount of
tension in the lock lever is attained.
NOTE: It may be neccesary to lock and unlock the miter
lock lever to determine proper tension.
Once all adjustments have been made, tighten the two
socket head cap screws and return the saw to an upright
position and push the miter lock lever down to lock the
miter table in place.
MITER LOCK
LEVER
SOCKET HEAD
CAP SCREWS
33 - English
PHILLIPS
SCREWDRIVER
BOTTOM VIEW OF SAW
UNLOCK
LOCK
Fig. 41
TENSIONING
SCREW
Fig. 42