IMG STAGELINE PSUB-215AK Manual De Instrucciones página 9

sound reproduced is not distorted. The LED
CLIP (7) lights up in case of overload of the sub-
woofer. In this case, turn back the control
accordingly.
3) Adjust the upper cut-off frequency (35 – 200 Hz)
for the subwoofer with the control FREQ (5) in
such a way that the subwoofer optimally com-
plements the sound of the other speakers. The
frequency adjusted is also the lower cut-off fre-
quency for the output HIGH-PASS OUTPUT (3).
If you connect a speaker system for reproducing
the midrange frequencies and high frequencies
to this output, the filters are used as a crossover
network. In this case, select the frequency
according to the frequency response of the
speaker system connected.
7 Specifications
Model
Amplifier power
RMS power
Peak power
Frequency range
Max. nominal SPL
Speaker
Voice coil
Input sensitivity
Max. input voltage
Input impedance
Low / High pass filter (adjustable cut-off frequency)
Ambient temperature
Power supply
Max. power consumption
Dimensions (W × H × D)
Weight
Pin configuration of connections:
All rights reserved by MONACOR
may be reproduced in any form or by any means for any commercial use.
PSUB-215AK
400 W
600 W
35 – 200 Hz
123 dB
∅ 38 cm (15")
∅ 10 cm, 8 Ω
230 V~/ 50 Hz
865 VA
450 × 615 × 610 mm
44.7 kg
1 = ground
2 = +
signal
3 = -
signal
INTERNATIONAL GmbH & Co. KG. No part of this instruction manual
®
If required, readjust the volume balance with
the control GAIN.
4) When the speakers are placed at different dis-
tances to the listener, phase cancellation may
result (certain frequencies are reproduced at a
lower volume). To compensate this effect,
reverse the phase of the subwoofer signal with
the switch PHASE (6).
Test both switch positions to find the position
offering the bass reproduction of the highest vol-
ume at the listening position. Then readjust the
volume balance with the control GAIN, if
required.
5) After use, switch off the subwoofer system with
the POWER switch.
500 mV
7 V
10 kΩ
35 – 200 Hz with 12 dB/ octave
0 – 40 °C
Subject to technical modification.
PSUB-218AK
500 W
700 W
30 – 200 Hz
125 dB
∅ 46 cm (18")
∅ 10 cm, 8 Ω
230 V~/ 50 Hz
1000 VA
600 × 750 × 750 mm
66.4 kg
T = signal +
R = signal -
S = ground
GB
9