Descargar Imprimir esta página

SoClean 2 Manual Del Usuario página 16

Ocultar thumbs Ver también para 2:

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

CONNECTION STEPS
After following these steps, your SoClean device will
disinfect your PAP machine daily without disconnecting.
Before you disconnect your PAP machine to wash the
parts, look at where the PAP hose is connected. You
will reconnect the SoClean Injection Fitting to the same
location.
Figure 1. Disassemble and Wash PAP Equipment
12 | CONNECTION STEPS
1. Pre-wash PAP Equipment
Disconnect your PAP mask, hose, and reservoir from the
PAP machine.
Use two capfuls of the included Neutralizing Pre-Wash
(may not be included in some countries) (fragrance-free
dish soap can be used) with a gallon (4L) of
water to wash your PAP equipment (mask,
hose, and reservoir) according to manufacturer
instructions (figure 1).
Rinse thoroughly with clean water.
Reinsert the reservoir (if used) into the PAP
machine. Do not reattach the hose or mask yet.
WARNING: Do not place Neutralizing Pre-Wash in the
PAP reservoir. Neutralizing Pre-Wash is for cleaning your
PAP equipment only.

Publicidad

loading

Productos relacionados para SoClean 2