Connect Power - SoClean 2 Manual Del Usuario

PAP Hose
(goes to mask)
Figure 3. Connect PAP Hose to Injection Fitting
Figure 4. Connect AC Power
14 | KEY PAP PARTS/SUPPORTED PAP MACHINES & ADAPTERS
Injection Fitting
(hose goes to
SoClean)
Without humidifier:
1. Pull off the small Injection Hose B from the
inside of the Injection Fitting.
2. Attach the Injection Fitting directly to your PAP
machine.
3. Reconnect your PAP hose to the end of the
Injection Fitting.
WARNING: Please be sure the black Injection Hose from
the back of the SoClean is connected to your PAP before
operating your SoClean device.
Note: If you are having difficulty connecting to your PAP, an
additional part may be necessary. Contact SoClean.com.
4. Connect the PAP Hose
Regardless of your humidifier, you can now connect
your PAP hose to the end of the Injection Fitting, which
is connected to your PAP machine (figure 3).

5. Connect Power

On the back of the SoClean device, plug the AC Adapter
in the connector marked DC 12V, 1.5A.
The AC Adapter should be plugged into a wall outlet
that is easy to access and observe. (Figure 4)
WARNING: In the event of loss of power to your home
or the SoClean device, ensure the proper Clock time and
Cycle Start time are set before using your PAP machine.
Failure to do so may result in the SoClean device operating
at an unexpected time.
6. Reconnect PAP Equipment
You can now reattach the mask to the end of the PAP hose.