AEG MRC 4122 F N Instrucciones De Servicio página 68

English
68
Inserting the Battery (Backup)
(Battery is not included with the device)
In case of a power cut or if the device is unplugged, with backup battery inserted, the set-
tings will be kept.
1. Open the battery compartment at the bottom. Remove for this the screw of the bat-
tery compartment lid with a Phillips screwdriver.
2. Insert one battery of the type CR2032, 3 V. Mind the correct polarity (indicated on the
bottom of the battery case)!
3. Close the battery case. Secure the battery compartment lid again with the screw.
If the device is not used for an extended period of time, remove the Battery from the
device to avoid any leaking of battery acid.
WARNING:
The batteries shall not be exposed to excessive heat such as sunshine, fire or the like.
Danger of explosion!
CAUTION:
Batteries are not to be disposed of together with domestic wastes. Dispose of the used
batteries at the relevant collection bin or at your dealer' s .
Power supply
• Make sure the grid voltage corresponds to the figures on the rating plate.
• Insert the plug into a properly installed power socket.
• If the power supply is interrupted and no backup battery has been inserted, all settings
(time, transmitter, alarms) done by you will be lost.
Switching the Unit On/Off
Press the button (3) to switch the unit on or off.
Volume
Use the / (5) and
Display brightness
Press the SNOOZE/SLEEP / DIMMER button (2) during standby mode to adjust the bright-
ness of the display.
/ NAP (6) buttons to adjust the volume.