AEG MRC 4122 F N Instrucciones De Servicio página 74

English
74
Cleaning
CAUTION:
Do not dip the appliance in water.
• Remove the plug before cleaning.
• Clean the appliance with a slightly humid cloth without any additives.
Troubleshooting
Problem
The unit cannot be oper-
ated
Device emits a signal sound
although "Wake up with
radio" has been selected
Alarm time cannot be
adjusted
Alarm time/Projection can-
not be switched on/off
Date and year cannot be
displayed
Cause
The unit is blocked and
"hangs"
A cable is connected to the
LINE IN jack
The unit is searching for a
radio signal (the " " symbol
is flashing)
The unit is searching for a
radio signal (the " " symbol
is flashing)
The unit is searching for a
radio signal (the " " symbol
is flashing)
Solution
Pull the mains plug for ap-
proximately 5 seconds. Then
connect the unit again
Disconnect the cable from
LINE IN jack
Wait until the radio signal
is being received (the " "
symbol lights up). This can
take several minutes.
Wait until the radio signal
is being received (the " "
symbol lights up). This can
take several minutes.
Wait until the radio signal
is being received (the " "
symbol lights up). This can
take several minutes.