Caution; Description; Technical Data; Equipotential Bonding - Weller WSB 80 Manual De Uso

English
Thank you for placing your trust in our company by purcha-
sing the Weller soldering bath WSB 80 / WSB 150. Production
was based on stringent quality requirements which guaran-
tee the perfect operation of the device.

1. Caution!

Please read these Operating Instructions and the attached
Safety Information carefully prior to initial operation. The ope-
rating instructions for the supply unit used are also applica-
ble in addition to these operating instructions. Failure to
observe the safety regulations results in a risk to life and
limb.
The manufacturer shall not be liable for damage resulting
from misuse of the machine or unauthorised alterations.
Safety Informations
 Repairs are only to be performed by authorised specialist
personnel.
 Only use those WELLER supply units that are suitable for
connecting to the solder bath.
 Do not store inflammable objects near the solder bath.
 Above 500°C there are lead emissions measurable.
 The small soldering bath remains hot for some time after
switch off.
 Avoid unintentional operation. Never leave the hot sold-
ring bath unsupervised.
 The soldering bath may only be operated in technically
flawless condition.
 Risk of burns due to liquid solder and solder splashes.
Wear appropriate protective clothing to protect yourself
from burns. Protect your eyes. Wear safety glasses.

Technical Data

Dimensions (mm):
Soldering Bath (mm):
Supply Voltage:
Power Rating:
Warm Up Time:
Temperature Range:
5
WSB 80
5,9" x 4,72" x 2,56" (L x W x H)
H = 25; ø = 20
24 V
80 W
Approx. 7 min. (50ºC - 350ºC)
50ºC - 450ºC

2. Description

The small soldering bath WSB 80 / WSB 150 was developed
for use in industrial manufacturing. The soldering bath is
suitable for connection to all supply units with an 80 W /
150 W connection. The solder bath temperature can be con-
trolled continuously from 50ºC - 450ºC via the supply unit to
which it is connected. The power supply (24 V safety extra
low voltage) is fed over a temperature resistant silicone
cable.
3. Commissioning
Ensure that there are no flammable or temperature sensitive
objects near the soldering bath.
Insert the soldering bath plug in the socket on the supply
unit and lock by turning clockwise. Switch on the supply
unit. Set the required temperature on the supply unit (50ºC -
450ºC). Soldering can be started after the necessary warm
up time.

4. Equipotential Bonding

The soldering bath is linked to the supply unit over an equi-
potential bonding wire. Various methods of realising equipo-
tential bonding are possible. The setting up of equipotential
bonding is described in the operating instructions for the
supply unit used.

5. Items Supplied

Small Solder Bath
Operating Instructions
Subject to technical change without notice!
See the updated operating instructions at
www.weller-tools.com.
WSB 150
5,9" x 4,72" x 2,56" (L x W x H)
2,3" x 1,2" x 0,75"(L x W x H)
24 V
150 W
Approx. 11 min. (50°C - 350°C)
50°C - 450°C