Equipment Assembly - Tramontina AP500S Manual De Uso

• Read the instructions carefully. Operators should be familiar with the controls and the proper use of the
equipment.
• This equipment is indicated for occasional use (domestic use).
• This equipment is recommended for occasional use (domestic use) in lawns of up to 50 square meters
(AP500S model) and 100 square meters (AP700, AP1000 and APR1000 models), to do the outlines, edges
and corners. The area may be larger or smaller depending on conditions of use: type of grass, height of
grass, the temperature, humidity, etc.
• Use the trimmer with the protector (protective skirt) always. The protector is a safety device for the
operator. In the protector, the cutting blade is fixed that limits the length of the nylon string, preventing
overload and consequent burning of the motor.
• The use of the equipment without the protective skirt, as well as, the nylon string outside of the
recommended diameter, is considered as warranty loss.
• Before turning on the equipment, check if the trimmer's electric tension is set in accordance with the local
electric tension.
Assemble the protector (2) on the body (1), such that the three latches of the body fit into the notches of the
protector, [Fig. 01, Pag. 03].
Fix the protector to the body with the three safety screws (3).
Fit the puller into the metallic arm and regulate (4) to the most comfortable working position, attaching it with the
corresponding nut (5), [Fig. 02, Pag. 03].
Before using the equipment, read carefully the usage and maintenance manual.
Before turning on the equipment, check if the trimmer's electric tension is set in accordance with the local electrical
tension.
For your security and to prevent the electric cable from being disconnected from the plug while the work is being
executed, bend the cable (1) and pass it through the opening (2), [Fig. 03 , Pag. 04], then fit it in the clamp (3), [Fig.
04, Pag. 04], only then connect the electric cable to the plug of the grass trimmer.
The trimmer must be used with both hands. Secure the grip with one hand and the handle with the other.
Keep the switch pressed down constantly during the work, avoiding oscillations of the rotation of the motor.
To turn off the trimmer, just release the switch.
The caliber of the electric cable must be in accordance with the table:
10 m
Section in 127 V 2 x 1 mm²
Section in 220 V 2 x 1 mm²
10 m
Section in 127 V 2 x 1 mm²
Section in 220 V 2 x 1 mm²
10 m
Section in 127 V 2 x 1 mm²
section in 220 V 2 x 1 mm²
QUICK GUIDE FOR USAGE

EQUIPMENT ASSEMBLY

OPERATION AND FORM OF USAGE
20 m 30 m
2 x 1 mm² 2 x 1 mm² 2 x 1,5 mm²
2 x 1 mm² 2 x 1 mm² 2 x 1 mm²
20 m 30 m
2 x 1 mm² 2 x 1.5 mm² 2 x 2.5 mm²
2 x 1 mm² 2 x 1 mm² 2 x 1 mm²
AP1000 and APr1000
20 m 30 m
2 x 1 mm² 2 x 1.5 mm² 2 x 2.5 mm²
2 x 1 mm² 2 x 1 mm² 2 x 1 mm²
AP500S
40 m 50 m
2 x 1,5 mm² 2 x 2 mm²
2 x 1 mm² 2 x 1 mm²
AP700
40 m 50 m
2 x 2.5 mm² 2 x 2.5 mm²
2 x 1 mm² 2 x 1 mm²
40 m 50 m
2 x 2.5 mm² 2 x 2.5 mm²
2 x 1 mm² 2 x 1 mm²
60 m 80 m 100 m
2 x 2,5 mm² 2 x 4 mm²
2 x 1 mm² 2 x 1.5 mm²
60 m 80 m 100 m
2 x 4 mm² 2 x 6 mm²
2 x 1,5 mm² 2 x 1.5 mm²
60 m 80 m 100 m
2 x 4 mm² 2 x 6 mm²
2 x 1.5 mm² 2 x 2.5 mm²
12