Monacor security TVCCD-400COL Manual De Instrucciones página 11

(2), the jack has the following pin configuration
(also see table on page 3):
Pin Position VIDEO
positive pole
1
of power supply
2 output of video signal
3 ground
4 ground
Attention! Prior to connecting the lens, check the
position of the switch AUTO IRIS and the pin con-
figuration of the plug to prevent damage to the
camera or the lens.
5 Mounting
The camera can be mounted to a wall or ceiling by
means of a mounting bracket (e. g. MONACOR TVH
series). For this purpose, an adapter (7) with a 6.3 mm
1
( / ") thread is provided on the lower side of the cam-
4
era. For ceiling suspension, screw the adapter onto
the upper side of the camera.
Position DC
damp -
damp +
drive +
drive -
For outside installation, the camera must be placed
in a weatherproof outdoor housing (e. g. MONACOR
TVG-300). For remote-controlled panning of the cam-
era, use a pan/tilt head (e. g. MONACOR VPT-50).
6 Connection
1) Connect the BNC output jack VIDEO OUT (1) to
a monitor via a 75 Ω cable (e. g. MONACOR
VEC-62/10). Observe the correct 75 Ω termination
on the monitor or, in case of series connection, on
the last monitor. With a cable length exceeding
100 m, a video amplifier should be inserted be-
tween the camera and the long cable to compen-
sate cable losses.
When using several cameras, insert a video
splitter (e. g. MONACOR TVSP-46COL) or a cam-
era switcher (e. g. MONACOR TVS-40 or TVS-80)
between the cameras and the monitor.
2) Connect the operating voltage of 12 V
power supply jack (4) via a low-voltage plug 5.5/
2.1 mm (outside/inside diameter) [inner contact =
positive pole]. An electronically regulated power
supply unit with an output voltage of 12 V is re-
GB
to the
11