Mitsubishi MELSEC-F FX2N Serie Manual De Hardware página 4

FX2N Series Programmable Controllers
Guidelines for the safety of the user and protection of the FX
This manual provides information for the installation and use of the FX
ENG
been written to be used by trained and competent personnel. The definition of such a person
or persons is as follows;
a) Any engineer who is responsible for the planning, design and construction of automatic
equipment using the product associated with this manual should be of a competent
nature, (trained and qualified to the local and national standards required to fulfill that
role). These engineers should be fully aware of all aspects of safety with regards to
automated equipment.
b) Any commissioning or service engineer must be of a competent nature, trained and
qualified to the local and national standards required to fulfill that job. These engineers
should also be trained in the use and maintenance of the completed product. This
includes being completely familiar with all associated documentation for the said
product. All maintenance should be carried out in accordance with established safety
practices.
c) All operators of the completed product should be trained to use that product in a safe
and co-ordinated manner in compliance to established safety practices. The operators
should also be familiar with all documentation which is connected with the actual
operation of the completed equipmen.
Note : The term 'completed equipment' refers to a third party constructed device which
contains or uses the product associated with this manual.
Notes on the symbols used in this manual
At various times through out this manual certain symbols will be used to highlight points of
information which are intended to ensure the user's personal safety and protect the integrity of
the equipment. Whenever any of the following symbols are encountered, its associated note
must be read and understood. Each of the symbols used will now be listed with a brief
description of its meaning.
Hardware Warnings
1) Indicates that the identified danger WILL cause physical and property damage.
2) Indicates that the identified danger could POSSIBLY cause physical and property
damage.
3) Indicates a point of further interest or further explanation.
Software Warnings
4) Indicates special care must be taken when using this element of software.
5) Indicates a special point of which the user of the associate software element
should be aware.
6) Indicates a point of interest or further explanation.
2N
. The manual has
2N
ii