Operating Procedure - Siemens LC8M950 Instrucciones De Uso Y De Montaje

Operating procedure

The most effective method of removing
vapours produced during cooking is to:
Switch the ventilator ON
as soon as you begin cooking.
Switch the ventilator OFF
a few minutes after you have finished
cooking.
Light
Fan OFF Reduce fan
speed
Acoustic signal:
When a button is pressed, this is verified
by an acoustic signal.
Switching off the acoustic signal:
Simultaneously press buttons 0 and +
until a signal is emitted after approx. 3
seconds.
Switching on the acoustic signal:
Repeat the process.
Switching the fan ON
Press the + button.
Setting the required fan speed:
Press the + button.
The fan speed is increased by one step.
Press the – button.
The fan speed is reduced by one step.
Switching the fan OFF:
Press the 0 button.
The displayed goes out shortly
{
afterwards.
Or:
Keep pressing the – button until the fan
switches off.
The displayed goes out shortly
{
afterwards.
Display for Fan follow-
fan setting on
Fan ON and
increase speed
Intensive setting
Intensive setting:
Maximum power is obtained at the
intensive setting. It is only required for short
intervals.
Keep pressing the + button until a
appears in the display.
If the intensive setting is not cancelled by
hand, the fan will automatically switch
back to step after 10 minutes.
}
Fan follow-on:
Press the button.
The fan continues to run at step
minutes, and at the same time a dot
flashes in the display. After this period
the fan switches off automatically.
Lighting:
The light can be switched on at any
time, even though the fan is switched off.
Adjusting the brightness:
Hold down the button until the
a
desired brightness is obtained.
ç
for 10
|
21