GE DPGT750 Manual Del Propietario E Instrucciones De Instalación página 29

Ocultar thumbs Ver también para DPGT750:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Installation instructions
CONNECTING
THE DRYER TO
HOUSE VENT
RiGiD METAL TRANSiTiON
DUCT
,, For best drying
performance,
a rigid metal
transition
duct is recommended.
,, Rigid metal transition
ducts reduce the risk
of crushing
and kinking.
UL-LISTED
FLEXIBLE METAL (SEMI-RIGID)
TRANSiTiON
DUCT
,, If rigid metal duct cannot
be used, then
UL-listed
flexible
metal (semi-rigid)
ducting
can be used (Kit WX08X10077).
,, Never install flexible
metal duct in walls,
ceilings,
floors
or other enclosed
spaces.
,, Total length
of flexible
metal duct should
not
exceed 8 feet (2.4 m).
,, For many applications,
installing
elbows
at
both the dryer and the wall is highly
recommended
(see illustrations
at right).
Elbows
allow the dryer to sit close to the wall
without
kinking
and/or
crushing
the transition
duct, maximizing
drying
performance.
,, Avoid
resting the duct on sharp
objects.
UL-LISTED
FLEXIBLE METAL (FOIL-TYPE)
TRANSITION
DUCT
,, In special
installations,
it may be necessary
to connect
the dryer to the house vent using
a flexible
metal (foil-type)
duct. A UL-listed
flexible
metal (foil-type)
duct may be used
ONLY in installations
where
rigid metal or
flexible
metal (semi-rigid)
ducting
cannot
be
used AND where
a 4" diameter
can be
maintained
throughout
the entire
length
of the transition
duct.
,, In Canada and the United
States, only the
flexible
metal (foil-type)
ducts that comply
with the "Outline
for Clothes
Dryer Transition
Duct, Subject
2158A"
shall be used.
,, Never install flexible
metal duct in walls,
ceilings,
floors
or other enclosed
spaces.
,, Total length
of flexible
metal duct should
not
exceed 8 feet (2.4 m).
,, Avoid
resting the duct on sharp
objects.
,, For best drying
performance:
1. Slide one end of the duct over the
clothes
dryer
outlet
pipe.
2. Secure the duct with a clamp.
3. With the dryer
in its permanent
position,
extend the duct to its full length.
Allow
2" of duct to overlap
the exhaust
pipe.
Cut off and remove
excess duct. Keep
the duct as straight
as possible
for
maximum
airflow.
4. Secure the duct to the exhaust
pipe with
the other clamp.
FOR TRANSITION
VENTING
(DRYER TO WALL),
DO:
• DO cut duct
as short
as
possible
and
install
straight
into wall.
• DO use elbows
when
turns
are
n ecessa ry.
DO NOT:
• DO NOT bend
or collapse
ducting.
Use
elbows
if turns
are necessary.
• DO NOT use
excessive
exhaust
length.
Cut duct as
short
as
possible.
• DO NOT crush
duct against
the wall.
• DO NOT set
dryer
on duct.
29

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido