Names And Functions Of Parts (Main Unit) - Teac UD-503 Manual Del Usuario

Names and functions of parts (main unit)

A B C
A
POWER switch
Use to turn the unit on and off.
o If the display is dark even though the POWER switch is set to
ON, the cause is usually one of the following.
• The power is on, but DIMMER (display brightness) is set to
OFF (page 19).
• The automatic power saving function has put the unit into
standby.
• The power cord is disconnected.
To turn the unit on, press the STANDBY/ON button on the
remote control, or set the power switch to OFF once and then
back to ON.
B
CLOCK indicator
This shows the clock synchronization status.
Lit: The unit is synchronized with the clock from the
CLOCK SYNC input connector (10MHz IN).
Blinking: No clock is being input or the unit is not being
synchronized.
Unlit: No clock sync is occurring.
o See page 18 for clock sync settings.
C
Digital audio input (OPT/COAX IN)
Use this to input digital audio.
Optical connection:
Coaxial connection:
D
INPUT SELECTOR knob
Use to select the input source.
Use to change setting values when a menu item is shown.
Press to use as an ENTER button.
Turn when the menu is open to change the item shown or the
setting value.
12
D E F
Use an optical cable with a mini plug.
Use the included RCA conversion cable.
G H
E
MENU button
Press to enter setting mode (page 17).
Press when in setting mode to return to the previous screen.
F
Remote control signal receiver
This receives signals from the remote control. When operating
the remote control, point it at the remote control signal receiver.
G
PHONES jacks
Connect headphones with a standard 6.3mm (1/4") stereo plug
here (page 11).
o If headphones are connected to this unit, audio will not be
output from the analog audio outputs on the rear panel.
H
Display
This display shows information about the audio playing back
and menu screens.
I
VOLUME knob
Use to adjust the headphones output volume. Turn right to
increase and left to decrease the volume.
o To enable adjustment of this unit's analog audio output
volume, set LINE OUT LEVEL to VARIABLE ("Line output level"
on page 19). This will enable adjustment of the analog
output level using this VOLUME knob.
o Volume settings are retained separately for analog audio
output and headphone output.
I