Reset All Values With The Calibration Device (Reset) - Balluff BTL7-A501-M -A-S32 Serie Manual De Instrucciones

BTL7-A/E501-M_ _ _ _-A/B/Y/Z(8)-S32/S115/S140/KA_ _/FA_ _
Magnetostrictive Linear Position Sensor – Rod Style
10

Reset all values with the calibration device (reset)

NOTICE!
Interference in function
Resetting all values while the system is running may
result in malfunctions.
► Stop the system before performing the reset.
The reset function can be used to restore all the settings to
the factory settings. For a reset the magnet may also be
located outside the measuring range.
Activate reset
Œ
► Simultaneously press
and
► Release buttons.
⇒ Reset is activated.
Reset
Œ ‚
► Press
and for at least 4 s.
► Release buttons.
⇒ All values are reset.
⇒ Current position value is displayed.
⇒ Reset is deactivated.
Abort reset
Resetting can be aborted without any changes
being saved after the Activate reset step.
► Briefly press Œ ‚
and simultaneously (< 1 s).
► Release buttons.
⇒ Current position value is displayed.
www.balluff.com
‚
for at least 4 s.
> 4 s
> 4 s
< 1 s
LED legend: LED not on
LED green
LED flashing green-red
LED display
LED1 LED2
1 2
1 2
1 2
LED 1 and LED 2 flashing green-red simultaneously
english 23