Remaining Risk Factors - Zipper Maschinen ZI-HAEK4100 Manual De Instrucciones

Biotrituradora
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

STORAGE NOTES:
Clean and dry the machine
Empty tank completely, avoid fuel spillage
Let cool down the engine
Store in a dry, out of reach of children place, well packaged
Do not store machines with fuels and fuels close to combustible and highly inflammable materials
as well as sparks and open flames.
Never remove the fuel tank cap when the engine is running or hot
Switch of the engine and remove the ignition key (if is available):
Before check, clean or work on the machine
Before eliminating faults
Before the start, after the failure or shock, be sure to check the device and make sure that it is in
good condition
If the shredder starts to vibrate abnormally, stop the engine immediately and locate the cause.
Vibrations generally terminate in malfunction.
Before refuelling
Always if you leave the machine

11.3 Remaining risk factors

It is important to ensure that each machine has remaining risks.
In the execution of all work (even the simplest) greatest attention is
required. A safe working depends on you!
Even if the machine is used as required it is still impossible to eliminate certain residual risk factors
totally. The following hazards may arise in connection with the machine´s construction and design:
• Risk of injury to the hands / fingers by negligent guiding the to be shredded material.
Guide the to be shredded material slowly and carefully into the in-feed. Automatic feeding!
• Risk of injury: hair and loose clothing, etc. can be captured and wound up! Safety regulations
must be observed with regard to clothing.
 Risk of injury by tilting the machine
• Risk of injury to the eye by flying debris, even with safety goggles.
• Risk of injury to the hearing by prolonged labor without hearing protection.
• Risk of burns: Touching the mufflers, exhaust and other machine components which can be hot
after prolonged continuous operation or when the engine is hot cause severe burns.
These risk factors can be minimized through obeying all security and operation instructions, proper
machine maintenance, proficient and appropriate operation by persons with technical knowledge and
experience.
In spite of all safety is and remains her healthy common sense and their corresponding technical
qualification / training for use of the machines most important safety factor!
ZIPPER MASCHINEN GmbH
ZI-HAEK4100 / ZI-HAEK11000
www.Zipper-Maschinen.at
W A R N I N G
SAFETY
27

Publicidad

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

Zi-haek1100091200392326909120039232683

Tabla de contenido