Stopping the Macchine:
Emergency-stop:
In case of danger and/or in an emergency situation, you can quickly stop the machine by
pressing the infeed emergency stop.
Normal stop
1. Set the throttle lever to "minimum" and let the engine run idle for approx. 3 minutes
at low engine speed.
2. Then set the engine ON/OFF switch (ignition switch) to the OFF position.
Only for ZI-HAEK11000: Turn the key (1) from position I to 0.
3. Close the fuel switch.
4. Wait until the engine has cooled down before storing the machine.
To wet material causes clogging
Insert the to be shredded material into the in-feed and when the material
is gripped by the machine and automatically feeded, release the material
immediately
Always feed in material with the thick end first
Saw off long side branches and insert them separately
Never work with too much pressure
Do not overload the machine
In the event of blockages, switch off the engine immediately and eliminate
any malfunctions.
Remove crosswise lying material only when the engine is switched off and
the blades are stopped!
Switch off the engine immediately if there are any unusual noise and
vibrations. Repair any faults immediately.
ZIPPER MASCHINEN GmbH
ZI-HAEK4100 / ZI-HAEK11000
www.Zipper-Maschinen.at
4.
Set the throttle lever to "half throttle" (=
middle position between "fast" and "slow").
Note:
Do not pull the starter rope through to
the end and do not let it rewind after
pulling, but only rewind it quickly.
5.
Grab the starter handle and pull it out
slowly. The resistance becomes strongest at
a certain point. This point corresponds to
the compression point. Let the rope roll
back a little from this point and then pull it
out powerfully.
Only for ZI-HAEK11000
Turn the Key from Position I to Start.
6.
Turn the choke lever to "Open when the
engine is running.
Open throttle further to increase the speed
before working with the Machine.
N O T I C E
OPERATION
(elektronic START):
35