Continuous Operation - EINHELL TE-RH 28 5F Manual De Instrucciones Original

ten the clamp.
First release the additional handle clamp. You can
then swing the additional handle (6) into the most
comfortable working position for you. Now turn
the additional handle in the opposite direction
again until the additional handle is secure.
5.2 Fitting and adjusting the depth stop (Fig.
3/Item 7)
The depth stop (7) is held in place by the additio-
nal handle (6) by clamping.
•
Release the locking screw (a) and insert the
depth stop (7).
•
Set the depth stop (7) to the same level as
the drill bit.
•
Pull the depth stop back by the required dril-
ling depth.
•
Retighten the locking screw (a).
•
Now drill the hole until the depth stop (7) tou-
ches the workpiece.
5.3 Changing the drill chuck (Fig. 4)
You can choose between the quick-change drill
chuck (11) and the SDS-Plus drill chuck (1).
Warning:
Always pull out the power plug before making ad-
justments to the equipment.
Fitting:
•
Pull back and hold the locking sleeve (2).
•
Turn and push the dust-free drill chuck into
the mount.
•
Allow the locking sleeve (2) to slide back to its
starting position again.
•
Check the lock by pulling the drill chuck.
Removing:
•
Pull back and hold the locking sleeve (2).
•
Remove the drill chuck.
5.4 Inserting the tool (Fig. 5-6)
Warning:
Always pull out the power plug before making ad-
justments to the equipment.
Note:
Release the depth stop as described in 5.2 and
push it towards the additional handle. This provi-
des free access to the chuck.
Anl_TE_RH_28_5_F_SPK9.indb 18 Anl_TE_RH_28_5_F_SPK9.indb 18
GB
5.4.1 Quick-change drill chuck (Fig. 5 / Item
11)
•
Open the chuck (11). The drill bit opening
must be large enough to hold the drill bit.
•
Select a suitable drill bit. Push the drill bit as
far as possible into the chuck opening.
•
Close the chuck (11). Check that the drill bit is
secure in the chuck (11).
•
Check at regular intervals that the drill bit or
tool is secure.
5.4.2 SDS-Plus drill chuck (Fig. 6 / Item 1)
•
Clean the tool before fitting it and apply a thin
coating of bit grease to the tool shaft.
•
Turn and push the dust-free tool into the tool
mounting as far as it will go. The tool will lock
automatically.
•
Check that the bit is locked in placed by
pulling on it.
To remove it, pull back and hold the locking slee-
ve (b) and remove the tool.
6. Operation
Danger
To prevent all danger, the machine must only be
held using the two handles (6/8). Otherwise there
may be a risk of suff ering an electric shock if you
drill into cables.
6.1 ON/OFF switch (Fig. 7/Item 4)
•
First fit a suitable drill bit into the tool
(see 5.4).
•
Connect the mains plug to a suitable socket.
•
Position the drill in the position you wish to
drill.
To switch on:
Press the ON/OFF switch (4)

Continuous operation:

Secure the ON/OFF switch (4) with the locking
button (5).
To switch off :
Press the ON/OFF switch (4) briefl y.
- 18 -
21.11.2017 07:54:13 21.11.2017 07:54:13