Tabla De Contenido; Important Safety Instructions - Delta 31-483 Manual De Instrucciones

IMPORTANT SAFETY INSTRUCTIONS ................................... 2
SAFETY GUIDELINES - DEFINITIONS .................................... 3
GENERAL SAFETY RULES ...................................................... 3
POWER CONNECTIONS .......................................................... 5
MOTOR SPECIFICATIONS ....................................................... 5
GROUNDING INSTRUCTIONS ................................................ 5
EXTENSION CORDS ................................................................ 6
FEATURES AND COMPONENTS ............................................. 6
FUNCTIONAL DESCRIPTION .................................................. 7
PRODUCT SPECIFICATIONS ................................................... 7
UNPACKING ..............................................................................7
ASSEMBLY ................................................................................8
Install Sanding Sleeves on Spindles .......................................................8
Install Spindles.................................................................................................8
Select and Install the Table Insert ............................................................9
Connect to Dust Collector .........................................................................9
On-Board Storage for Spindles and Table Inserts ......................... 10

IMPORTANT SAFETY INSTRUCTIONS

READ AND UNDERSTAND ALL WARNINGS AND OPERATING INSTRUCTIONS BEFORE USING THIS
EQUIPMENT. Failure to follow all instructions listed below, may result in electric shock, re, and/or
serious personal injury or property damage.
Woodworking can be dangerous if safe and proper operating procedures are not followed. As with all
machinery, there are certain hazards involved with the operation of the product. Using the machine with
respect and caution will considerably lessen the possibility of personal injury. However, if normal safety
precautions are overlooked or ignored, personal injury to the operator may result. Safety equipment such as
guards, push sticks, hold-downs, featherboards, goggles, dust masks and hearing protection can reduce your potential
for injury. But even the best guard won't make up for poor judgment, carelessness or inattention. Always use common
sense and exercise caution in the workshop. If a procedure feels dangerous, don't try it. Figure out an alternative
procedure that feels safer. REMEMBER: Your personal safety is your responsibility. For additional information please
visit our website www.DeltaMachinery.com.
This machine was designed for certain applications only. DELTA
recommends that this machine not be modi ed and/or used for any application other than that for
which it was designed. If you have any questions relative to a particular application, DO NOT use the machine until you
have rst contacted DELTA
®
If you have any questions relative to its application DO NOT use the product until you have written DELTA
Corporation and we have advised you. Contact us online at www.DeltaMachinery.com or by mail at Technical Service Manager,
DELTA Power Equipment Corporation, 2651 New Cut Road, Spartanburg, SC 29303.
®
Information regarding the safe and proper operation of this tool is available from the following sources:
• Power Tool Institute, 1300 Sumner Avenue, Cleveland, OH 44115-2851or online at www.powertoolinstitute.com
• National Safety Council, 1121 Spring Lake Drive, Itasca, IL 60143-3201
• American National Standards Institute, 25 West 43rd Street, 4 oor, New York, NY 10036 www.ansi.org - ANSI 01.1
Safety Requirements for Woodworking Machines
• U.S. Department of Labor regulations www.osha.gov
TABLE OF CONTENTS
to determine if it can or should be performed on the product.
OPERATION ............................................................................10
ADJUSTMENTS .......................................................................11
Adjusting Table Tilt .....................................................................................11
Squaring the Table to the Spindle ........................................................ 11
RECOMMENDED MAINTENANCE ........................................ 12
Lubrication .....................................................................................................12
Routine Inspection ....................................................................................12
Replacing Sanding Sleeves ....................................................................12
ACCESSORIES ........................................................................12
WARRANTY .............................................................................13
REPLACEMENT PARTS ..........................................................13
SERVICE AND REPAIRS .........................................................13
FRANÇAIS ................................................................................14
ESPAÑOL .................................................................................27
Power Equipment Corporation strongly
®
2
Power Equipment
®