InMotion SCV V5 Manual De Usuario página 37

temperature and at least once every month later.
3.2. Air Inflation and Inner and Outer Tire Replacement
If the tire pressure is insufficient, please conduct air inflation in time. The factory tire pressure of INMOTION SCV V5 is 2.8Bar by
default. If the tire of INMOTION SCV V5 needs to be replaced due to tire burst, etc., please contact the dealer authorized by
INMOTION IBERIA or the after-sales service department of INMOTION IBERIA for maintenance.
3.3. Pedal Tightness Adjustment
Riders will feel uncomfortable if the pedals of INMOTION SCV V5 become loose, and will even fall under severe condition. If the
pedals become loose, please respectively use a M10 Allen driver and a M6 Allen driver to tighten the screws on the axis and on the
side edge of the axis. Please develop a habit of checking all parts of the INMOTION SCV V5 before using.
3.4. Precautions for Cleaning and Use
· Before cleaning the scooter, the body shall be shut down. Charging wire shall be pulled up, and the charging port shall be closed.
During rinsing, make sure that water does not flow into the battery-charging port.
· Use a soft cloth dipped with soapy water or clean water to scrub the outer cover of the INMOTION SCV V5. Do not use high-
pressure water jet to flush the INMOTION SCV V5.
· The waterproof and dustproof level of the INMOTION SCV V5 is IP55, which means splash-proof and dustproof. Therefore, it is
not allowed to dip the INMOTION SCV V5 in water, which may cause permanent damage to the scooter.
· Please do not drive the INMOTION SCV V5 to pass through the deep-water zone (more than 70mm in depth). Please do not drive
in the rainstorm, so as not to fall down or cause damages to the scooter because of being soaked in the water.
· Please do not place the INMOTION SCV V5 near the fire source or the places with extremely high temperature, so as to avoid
battery damages even explosion caused by hidden fire-fighting dangers.
37