Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
O
PERATION
Auto Switch
The Auto Switch function cycles through all of the test pattern modes at an adjustable rate.
1.
Access the
Test Pattern
2.
Turn the <SCROLL/ENTER> knob until Auto Switch is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select from Off, or 1–10s.
5.
Press the <SCROLL/ENTER> knob.
Picture In Picture
The PIP (Picture In Picture) function allows 2 input sources to be displayed on the connected panel
assembly at once.
To access the PIP menu:
1.
Press <MENU> to access the menu.
2.
Turn the <SCROLL/ENTER> knob until PIP is selected.
3.
Press the <SCROLL/ENTER> knob.
To enable or disable PIP:
1.
Access the
PIP
menu.
2.
Turn the <SCROLL/ENTER> knob until PIP is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select Off or On.
5.
Press the <SCROLL/ENTER> knob.
Input Selection
There are two methods of selecting the inputs in PIP mode. For button options, see
To select both inputs through the menu:
1.
Access the
PIP
menu.
2.
Turn the <SCROLL/ENTER> knob until Input is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select from:
•
Default (Input settings will be unchanged),
•
HDMI/DVI (Input 1: DVI, Input 2: HDMI),
•
HDMI/SDI (Input 1: SDI, Input 2: HDMI),
•
SDI/DVI (Input 1: DVI, Input 2: SDI),
•
SDI/HDMI (Input 1: HDMI, Input 2: SDI),
•
DVI/HDMI (Input 1: HDMI, Input 2: DVI),
or
•
DVI/SDI (Input 1: SDI, Input 2: DVI).
5.
Press the <SCROLL/ENTER> knob.
Position
The position setting determines where on the connected panel assembly the input designated as PIP will
be displayed.
1.
Access the
PIP
menu.
2.
Turn the <SCROLL/ENTER> knob until Position is selected.
3.
Press the <SCROLL/ENTER> knob.
4.
Turn the <SCROLL/ENTER> knob clockwise or counterclockwise to select from:
•
L+T (Top left of the panel assembly),
•
R+T (Top right of the panel assembly),
•
L+B (Bottom left of the panel assembly),
•
R+B (Bottom right of the panel assembly),
•
Cent (Center of the panel assembly),
•
L+R (One input on the left, the other on the right of the panel assembly),
or
•
T+B (One input on the top, the other on the bottom of the panel assembly).
5.
Press the <SCROLL/ENTER> knob.
VIP Drive 43s User Manual Rev. 1
menu.
Input
Mode.
24
Publicidad
Tabla de contenido
