Preparations Before Using The Pk-6; Inserting Batteries; Battery Life; Battery Charge Indication - Roland PK-6 Manual Del Usuario

Dynamic MIDI Pedal PK-6

Preparations before using the PK-6

3. Preparations before using the PK-6

Inserting batteries

The PK-6 can be powered with the 6 supplied LR6
AA-type batteries or equivalent replacement batte-
ries.
1.
Remove the lid from the PK-6's battery
compartment by pressing the tab and lifting
the lid.
2.
Insert 6 AA-type batteries (supplied) into
the battery compartment (3 on either side),
taking care to orient them in accordance
with the "+" and "–" indications.
3.
Close the battery compartment: first insert
the catches on the lid into the matching
cavities, then push the lid down firmly until
you hear a click.

Battery life

Continued use
NOTE
The battery life given here is only an approximation. It will
vary depending on the frequency and conditions of use.

Battery charge indication

If, while using batteries, three dots "..." appear in the
display, the remaining battery power is low. In this
case, replace the batteries at your earliest conveni-
ence.
Mon . . .
If the three dots and the display message flash, you
need to replace the batteries right away (or use an
optional adaptor).
Checking the battery charge
The PK-6 also allows you to check the remaining bat-
tery charge at any time:
10
Approximately 16 hours
Lit three dots: remaining battery power
is low.
Flashing three dots and current mes-
sage: replace batteries now.
1.
Press the [SHIFT/ENTER] footswitch to acti-
vate the secondary footswitch functions
(the indications below the footswitches).
The [SHIFT] indicator lights. The display shows "---".
2.
Press the [HOLD/PARAMETER] footswitch.
The [PARAMETER] indicator flashes.
ret
The display will indicate "rEt" to signal the PK-6 is
now in Parameter mode.