Downloading Further Instructions - Balluff BAE PS-XA-1S-24-200-104 Manual De Instrucciones

Switching mode power supplies IO-Link ready
BAE PS-XA-1S-24-200-104
Validity
This guide is valid for the following devices:
– BAE PS-XA-1S-24-200-104 (ordering code BAE00M3)
Fig. 1: Product view
Intended use
This device is a primary switched-mode power supply for
integration in control panel installations or integrated
applications where access to the power supply is restric-
ted (contact protection).
This product is designed for an industrial environment and
is suitable for Pollution Degree 2.
Modifications to the device or non-approved use are not
permitted and will result in loss of warranty and void any
liability claims against the manufacturer.
Non-intended use
These devices must not be used in applications in which
the safety of people is dependent on the function of the
device (not a safety component acc. to EU Machinery
Directive).
Do not use in wet locations or in areas where moisture or
condensation can be expected.
Scope of delivery
– Switching mode power supply
– This guide
Approvals and markings
EU Directive 2004/108/EC (EMC Directive);
Low Voltage Directive 2006/95/EC.
Product standard EN 61204-3; Safety of
Information Technology Equipment EN /
IEC 60950-1
Safety of Information Technology Equipment
(E324645) UL60950-1 and CSA C22.2
No. 60950-1-07
Safety of Industrial Control Equipment
(E324646) UL 508, and CSA C22.2
No. 07.1-01
www.balluff.com

Downloading further instructions

The user's guide can also be downloaded from the Internet
at www.balluff.com.
Safety notes
Installation and startup may only be performed by
trained specialists with basic electrical knowledge.
Qualified personnel are persons whose technical trai-
ning, knowledge and experience as well as knowledge of
the relevant regulations allows him to assess the work
assigned to him, recognize possible hazards and take
appropriate safety measures.
The operator is responsible for ensuring that local safety
regulations are observed. In particular, the operator must
take steps to ensure that a defect in the measuring system
will not result in hazards to persons or equipment.
If defects and persistent faults occur in the device, take it
out of service and secure against unauthorized use.
Original instructions. Technical personal must have
carefully read and understood the instructions before
beginning any work. For any clarifications the German
version shall be used.
Always observe the safety instructions in this guide and the
measures described to avoid hazards.
Explanation of the warnings
The warnings used here contain various signal words and
are structured as follows:
SIGNAL WORD
Type and source of the hazard
Consequences if not complied with
► Measures to avoid hazards
The individual signal words mean:
NOTICE
Identifies a danger that could damage or destroy the
product.
DANGER
The general warning symbol in conjunction with the
signal word DANGER identifies a hazard which, if not
avoided, will certainly result in death or serious injury.
english 1