Programming Instructions - Fracarro DIGIFLEX SIG9708CI Instrucciones De Funcionamiento

output audio
adjustment
green led
red led
output video
adjustment
flat cable
connector
NOTE: when the boards 7 and 8 are used in modulator mode, the red LED will flash.
3.2 INSERT THE CAM IN THE SLOT COMMON INTERFACE
To insert and remove the CAM from the slot common interface of a Master or Stand-alone receiver, open the
headend front panel with the key and insert/remove the CAM (not supplied) in the slot common interface in
the bottom part of the receiver. Refer to Figure 6 and 7.
ATTENTION: when you use the CAM (not supplied), take note of the maximum operating temperature
declared by the manufacturer.
WARNING: scrolling the channel list the "encrypted program" message might be displayed, even if you own
the decoding rights. Wait a few seconds and the display and decoding will continue automatically (the video
display wait is directly dependent from the CAM).
WARNING: a few functions of the CAM are accessible only after they are enabled. For further information
see the CAM menu (menu: COMMON INTERFACE – CI MENU).
To program and display the internal status of the headend, use a TPE programmer. Each receiver must be
singularly programmed by setting all the parameters that single out the SAT program in the input and define
the output channel (in the VHF or UHF band). Connect the programmer to one of the two RJ45 plugs (see Fig.
1), (please wait a few seconds, TPE searching line of device, when the TPE arrive to the number of receivers
press key), to enter all the receivers; the TPE switches on automatically and shows the Fracarro logo.
Press any key of the keyboard (except the
To set the TPE language, enter the "TPE SETUP" --> "LANGUAGE" menu. Choose the language by scrolling
with the arrows and confirm with the
the TPE arrive to the number of receivers press
For other TPE settings, refer to the instruction sheet of the TPE programmer, or from page 26 to page 27.
To enter the OSD (On Screen Display), enter the HEADEND SETUP -> OSD NAVIGATION and confirm it with
the key.
FRONT VIEW OF RECEIVER
audio left
audio right
video
Fig. 15 Selection of SAT receiver mode or modulator

4. PROGRAMMING INSTRUCTIONS

key).
key. (please wait a few seconds, TPE searching line of device, when
Selection
SUB-D
15 pin
EXT
SAT
EXT
ONLY FOR SAT
MODULE
EXT
n° 7 & n° 8
SAT
selection
EXT
Audio & Video
SAT
IN/OUT
EXT
SAT
EXT
SAT
key).
23
audio
left
SAT
audio
RECEIVER
right
MODE
video
audio
left
MODULATOR
audio
right
MODE
video