White Balance; Slow Response Of The Leds - IMG STAGELINE ODC-100/ RGB Manual De Instrucciones

2) Press the button UP or DOWN repeatedly
until the display indicates
3) Press the button ENTER. The display indi-
cates
.
4) Press the button UP or DOWN repeatedly
until the display indicates
5) Press the button ENTER and then use the
button UP or DOWN to select:
= maximum brightness
= brightness reduced to 33 %
6) To be able to control the spotlight by DMX,
use the button MENU to return to the highest
menu level.
For independent operation, use the but-
ton MENU to select the operating mode and
then press ENTER to activate the mode
selected.

5.2 White balance

The factory setting of the spotlight is such that
the colours red, green and blue – when set to
maximum brightness – result in a specific shade
of white. This shade of white may be changed to
appear warmer or cooler, e. g. to level out the
differences to other spotlights when they are
controlled together with the ODC-100 / RGB or
PARC-100 / RGB.
1) Press the button MENU repeatedly until the
highest menu level has been reached.
2) Press the button UP or DOWN repeatedly
until the display indicates
3) Press the button ENTER. The display indi-
cates
4) Press the button ENTER again. The display
now indicates
between 000 and 255.
= brightness of colour red
= brightness of colour green
= brightness of colour blue
5) Use the button ENTER to select the three
setting options one after the other; use the
button UP or DOWN to set the brightness for
the individual colours and thus to create the
shade of white desired.
6) To activate the shade of white that has been set:
a) Press the button MENU repeatedly until
the display indicates
b) Press the button DOWN twice so that the
display indicates
22
.
, , ,
.
.
, or and a number
again.
.
c) Press the button ENTER. The display
d) Press the button UP or DOWN repeatedly
, or
e) Press the button ENTER. If the display
7) To be able to control the spotlight by DMX,
press the button MENU twice to return to the
highest menu level.
ton MENU to select the operating mode and
then press ENTER to activate the mode
selected.

5.3 Slow response of the LEDs

LEDs immediately respond to a change of the
brightness setting. To simulate the slow re-
sponse of standard lamps, the response can be
set in four steps. For the 10-channel mode
( fig. 7). For 3-, 4- and 5-channel mode, make
the setting as follows:
1) Press the button MENU repeatedly until the
highest menu level has been reached.
2) Press the button UP or DOWN repeatedly
until the display indicates
3) Press the button ENTER. The display
changes to
or
.
4) Press the button UP or DOWN repeatedly
until the display indicates
5) Press the button ENTER. The display indi-
cates the current setting:
Use the button UP or DOWN to select the
setting desired.
6) To be able to control the spotlight by DMX,
use the button MENU to return to the highest
menu level.
ton MENU to select the operating mode and
then press ENTER to activate the mode
selected.
changes to ,
or .
until the display indicates
indicates , the shade of white is acti-
vated; if it indicates
UP or DOWN to set the indication to
For independent operation, use the but-
, the setting is made via DMX channel 9
,
.
= immediate response
= slightly slow response
= slow response 2
= slow response 3
= slowest response
For independent operation, use the but-
, , ,
.
, use the button
.
.
, , ,
.