De Dietrich DLZ 614 JE1 Manual De Instalacion Y Uso página 73

Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

CONNECTION TO THE MAINS WATER SUPPLY AND
2
DRAINAGE
CONNECTION TO THE
MAINS WATER SUPPLY
The water supply hose is inside the drum:
a Connect the bent end of the hose to the
threaded inlet of the electrovalve located
at the rear of the washing machine.
b Connect the other end of the hose to
the water intake. Then securely tighten
the connection nut.
It is important that the drain hose
bend is correctly fastened to the
outlet, to prevent any risk of it
becoming detached and causing
flooding.
If your washing machine has a hot
water intake, connect the hose with
the red threaded end to the hot water
tap, and to the electrovalve with the
red filter.
The washing machine must be
connected to the mains water supply,
using the new supply hoses supplied
with the appliance. Do not use water
supply hoses that have been used
before.
For your washing machine to work
properly, the mains water pressure
must be between 0.05 and 1MPa (0.05
2
and 10 Kgr/cm
).
a It is recommended that you have a fixed
drainage outlet 50 to 70 cm from the
floor.
Avoid the drain hose being too tight,
kinked or restricted.
DRAINAGE
CONNECTION
installation and assembly
73

Publicidad

Tabla de contenido
loading

Tabla de contenido