Lamp (Re)Placement; Overhead Rigging - Briteq MEGA-STROBE 1500 DMX Manual De Instrucciones

ENGLISH
DESCRIPTION:
1. Mains Cable
2. Automatic fuse: press this button to reset.
3. Hanging bracket with knobs on both sides to fasten
the unit and a mounting hole to fix a mounting hook.
4. Dip Switches: includes 2 special function switches + 9
Address Dip Switches that can be used to set the
DMX start address.
5. Manual Intensity control of the flash
6. Manual flash rate control (speed)
7. DMX output: used to connect the next item in the
DMX chain. Use balanced XLR signal cables of good
quality.
8. DMX input: Used to connect to a DMX controller or to
the previous item in the DMX chain. Use balanced
XLR signal cables of good quality.

LAMP (RE)PLACEMENT

Strobe tubes should be replaced by qualified technicians only !
Strobe tubes contain poisonous chemicals. Discard used strobe tubes appropriately.
Keep out of reach of children and animals.

OVERHEAD RIGGING

 Important: The installation must be carried out by qualified service personal only. Improper
installation can result in serious injuries and/or damage to property. Overhead rigging requires
extensive experience! Working load limits should be respected, certified installation materials
should be used, the installed device should be inspected regularly for safety.
 Make sure the area below the installation place is free from unwanted persons during rigging, de-rigging
and servicing.
 Locate the fixture in a well ventilated spot, far away from any flammable materials and/or liquids. The
fixture must be fixed at least 50cm from surrounding walls.
 The device should be installed out of reach of people and outside areas where persons may walk by or be
seated.
 Before rigging make sure that the installation area can hold a minimum point load of 10times the device's
weight.
 Always use a certified safety cable that can hold 12times the weight of the device when installing the unit.
This secondary safety attachment should be installed in a way that no part of the installation can drop
more than 20cm if the main attachment fails.
 The device should be well fixed; a free-swinging mounting is dangerous and may not be considered!
 Don't cover any ventilation openings as this may result in overheating.
 The operator has to make sure that the safety-relating and machine-technical installations are approved by
an expert before using them for the first time. The installations should be inspected every year by a skilled
person to be sure that safety is still optimal.
ELECTRICAL INSTALLATION + ADDRESSING
Important: The electrical installation should be carried out by qualified personal only,
according to the regulations for electrical and mechanical safety in your country.
Set the first special function DIP switch (~Hz) accordingly to your Mains Network:

Connected Power = 60Hz --> Dip Switch must be set to ON

Connected Power = 50Hz --> Dip Switch must be set to OFF
BRITEQ
®
3/30 MEGA STROBE 1500 DMX
OPERATION MANUAL