Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
5 Starting up the studio flash unit
In order to prevent damage to the studio
flash unit, please start-up the studio flash
unit for the first time by taking the following
steps in the given order.
1. Remove the protective cap (see 5.1.1);
2. Plug in the bulb of the modelling lamp
3. Attach the reflector (see 5.1.3);
4. Mount the studio flash unit on a tripod
5. Connect the studio flash unit to a power
6. Switch on the studio flash unit (see 5.1.6).
The individual operations are described in
detail in the following pages.
Observe all the safety instructions that are
k
given!
5.1 Starting up the studio flash unit
66
(see 5.1.2);
(see 5.1.4);
supply (see 5.1.5);
step-by-step
During all steps, always make sure the
you
- never touch the flash tube or bulb of the
modelling lamp.
- always allow the studio flash unit to
cool down for approximately 30 minutes
after use.
5.1.1 Removing/replacing the protective cap
- Removing the protective cap
- Push release lever
held there.
- Twist the protective cap in a counter-
clockwise direction as far as it will go
and then lift it off the studio flash unit.
- Let go of release lever
- Put on the protective cap.
- Push release lever
held there.
- Plug the protective cap into the plug-in
openings on the studio flash unit and
twist it in a clockwise direction until
you feel it snap into place.
- Let go of release lever
5.1.2 Plugging in/unplugging the bulb of the
modelling light
+
The 120V bulb of the modelling lamp in
the delivery contents is suitable for mains
voltages between 90V to 250V.
See picture E.
The studio flash unit must be switched
off and the power plug must be pulled
out of the power socket.
Always use a clean, grease-free cloth or
cotton gloves to take hold of bulb a.
- Plug in bulb a
- Carefully plug the bulb into the socket.
back and keep it
.
back and keep it
.
Publicidad
Capítulos
Tabla de contenido
