Connecting The Studio Flash Unit To The Power Mains; Switching The Studio Flash Unit On/Off - Metz Mecastudio BL-200 Manual De Instrucciones

5.1.5 Connecting the studio flash unit to the

5.1.6 Switching the studio flash unit on/off

- Switching on the studio flash unit: Press power
switch 6 so that it is in position
k
S
5. 6
E
R
V
O
+
The automatic soft start protects the flash
tube of the studio flash unit. Therefore, the
set flash output will be reached after appro-
ximately 1-2 seconds.
68
power mains
The studio flash unit must be switched
off.
The connected loads of the studio flash
unit (see chapter 13 Technical data)
must match the values of the local power
grid.
- Plug the power cord into the socket 5 on
the studio flash unit.
- Plug the power plug into the power
socket.
You must remove the protective cap
before switching on the studio flash unit!
I (ON)
- The DIGITAL DISPLAY shows the
flash output that is currently set.
- The FLASH READY LED
starts to illu-
minate when the set flash output is
reached.
- The following LED/lamps illuminate if
they were switched on when the studio
flash unit was switched off:
- the bulb of the modelling lamp
- the LED of the MODELLING LAMP
function.
- the LED of the TONE
- the LED of the SERVO
- Switching off the studio flash unit:
Press power switch so that it is in
position 0 (OFF)
- All displays go off.
- If the modelling lamp was switched on,
it goes off.
function.
function