Imetec Bellissima SensEpil Lux 5030 Instrucciones De Uso página 81

COVERING THE ENTIRE TREATMENT AREA
A precise technique must be followed during the session to make sure the entire
treatment area is covered and dangerous overlapped pulses are prevented:
• Imagine the treatment area is divided in rows.
• Emit a light pulse proceeding in order, starting from one end of each row
and continuing to the other end (from the bottom upwards or right to left,
depending on the treatment area).
The area covered by the treatment surface (17) leaves temporary marks on
the skin due to the light pressure applied by the handpiece.
These marks remain visible for a few moments and are useful to establish the
subsequent pulse position.
ATTENTION
Do not overlap the pulses!
Do not treat the same section of skin more than once per hair removal session!
STOP USING THE APPLIANCE IMMEDIATELY if excessive heat or tingling
is felt or blisters or small burns appear on the skin!
HOW TO PERFORM THE PATCH TEST
Since the skin tone varies from one body part to another, a patch test should
be performed on each part of the body that is to be treated.
EN
77