Problems And Solutions - Imetec Bellissima SensEpil Lux 5030 Instrucciones De Uso

PROBLEMS AND SOLUTIONS

1. Make sure that the connector (7b) is inserted correctly into the
The appliance
base connection (6).
does not
2. Make sure that the power supply plug (7a) is inserted into a wall
go on
socket.
1. Make sure the surface treatment (17) is evenly and firmly
pressed on the skin. OR
2. Check the skin colour check LED (15): if it flashes for 3 seconds,
the skin tone is too dark for a safe application. Try to use the
appliance on another part of the body or contact the IMETEC
service centre. OR
3. Check the lamp replacement LED (14): If it stays on, contact the
No light is
emitted when IMETEC Customer Service Centre. OR
the pulse 4. Verify that the ready-for-use LED (11) is on.
activation If the ready-for-use LED (11) remains off after 10 seconds, switch
button (19) the appliance off and on again by pressing the switch-on/stand-by
is pressed button (8) twice.
If the problem persists, contact the IMETEC Customer Service
Centre. OR
5. Check the error/fault LED (16): if the LED is on, switch the
appliance off and on again by pressing the switch-on/stand-
by button (8) twice. If the problem persists, contact the IMETEC
Customer Service Centre.
EN
83