How To Charge - AnyTone AT-D878UV Manual De Instrucciones

Transceptor portátil analógico/digital dmr bibanda (vhf/uhf) para radioaficionados.
Ocultar thumbs Ver también para AT-D878UV:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

WARNING:
» When keys, ornamental chain or other electric metals contact the
battery terminal, the battery may become damage or injure a human.
If the battery terminals are short circuited it will generate a lot of heat.
Take care when carrying and using the battery. Remember to put the
battery or radio into an insulated container. Do not put it into a metal
container.

How to Charge

2.4
a.
Plug the AC adaptor into the AC outlet, and then plug the cable of the
AC adaptor into the DC jack located on the back of the charger. The
indicator light blinks orange and is then ready to charge a battery.
b.
Plug the battery or the radio into the charger. Make sure the battery
terminals are good in contact with charging terminals. The indicator light
turns to red--- charging begins.
c.
It takes approximately 2-5 hours to fully charge the battery. When the
lamp lights green, the charging is completed. Remove the battery or the
radio unit with its battery from socket
» when charging a radio (with battery) the indicating lamp will
not turn into green to show the fully charged status if the radio
is powered on. Only when the radio is switched off will the lamp
indicate normal operation. The radio consumes energy when it
is power-on, and the charger cannot detect the correct battery
voltage when the battery has been fully charged. So the charger
will charge the battery in constant voltage mode and fail to
indicate correctly when the battery has been fully charged.
AT-D878UV Digital DMR and Analog UHF/VHF Two Way Radio
2. BATTERY INFORMATION
4

Hide quick links:

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido