Imetec Scaldasonno Adapto M 6T Instrucciones De Uso página 20

• fold it like a normal blanket;
• you are advised to store the underblanket in the original packaging it was supplied in;
• when storing the appliance, allow it to cool down before folding;
EN
• put the underblanket away in a dry place
The fabric may turn yellow over time. This does not have any effect at all on the safety and/or
effectiveness of the product itself.
Examine the appliance and its supply cord frequently for signs of wear or damage.
lf there are such signs or in the case of malfunction, contact an authorised technical
service centre.
This chapter describes the most common problems that can arise using the appliance. If the problems cannot
be solved with the information below, please contact the Authorised Assistance Centre.
Problem
The LEDs on the control unit do not light
up.
The blue warning light is flashing.
Temperature LED 1 (11) is flashing.
The product has been used incorrectly or
is damaged.
The power cable or another internal wire
is damaged.
The control unit is damaged.
There are holes or tears in the fabric or
stubborn creases that do not spread out.
The packaging of the appliance is made of recyclable materials. Dispose of the packaging in
accordance with the environmental protection regulations.
19
TROUBLESHOOTING
Check that the control unit plug is fully inserted in the socket (3). If the
LEDs remain off, remove the control unit plug from the socket (3) and
return the underblanket to an authorised technical service centre.
Turn the control unit off and remove the plug from the socket (3).
Check that the control unit connector (2) is fully inserted in the
underblanket connector (1) and reinsert the plug in the socket (3).
If the standby LED continues to flash, return the underblanket to an
authorised technical service centre.
Return the underblanket to an authorised technical service centre to
be checked.
DISPOSAL
Solution