Connecting The Control Unit - Imetec Scaldasonno Adapto M 6T Instrucciones De Uso

• Make sure the underblanket is always spread out smoothly and that there are no
creases.
• Make the bed, laying the mattress cover and/or the first sheet on top of the underblanket.
Place the second sheet and the normal blanket or duvet on top.

CONNECTING THE CONTROL UNIT

• Insert the control unit connector (2) in the underblanket connector (1) to connect the
control unit to the underblanket.
• For the double bed model, repeat the operation for the second control unit as well.
• Run the control unit cable along the floor next to the bed. Do not squash the control
unit cable between the mattress and the bed frame.
• Insert the plug of the control unit cable in the mains socket (3). Every time the plug is
inserted, the control unit automatically performs a self-diagnosis, lighting up all LEDs
(10, 11) in a clockwise sequence for around two seconds.
SWITCHING ON AND SELECTING THE RIGHT TEMPERATURE
The control unit can be set to the following temperature levels:
6: rapid preheating temperature
3-5: customised temperatures
1-2: minimum temperatures for continuous or night-time use
• To switch the underblanket on press the ON/OFF button (7). Every time the appliance is
turned on, the control unit automatically checks the appliance is working correctly, lighting up
all LEDs (10, 11) in a clockwise sequence. Following this check, the control unit automatically
sets temperature 6 and the timer (auto-off time) to 1 hour.
• For rapid preheating of the bed, use maximum temperature 6. During warmer periods, it is
possible to preheat the bed by selecting temperatures 3 to 5 by pressing the temperature
selector button (8) until the LED for the required temperature lights up (11). The higher the
number selected, the higher the temperature.
IMPORTANT: The time needed for the underblanket to warm up will depend on the
room temperature. The temperature of the underblanket must be evaluated by lying
in the bed rather than just feeling it by hand.
NIGHT-TIME OR CONTINUOUS USE
For night-time or continuous use of the appliance, set the
control unit to temperature levels 1 or 2 only.
To set the control unit to the continuous use temperature, press the temperature selector button
(8) until LEDs 1 or 2 light up (11).
EN
16