Maintenance And Cleaning - Imetec Bellissima My Pro 2 in 1 Straight & Waves B29100 Instrucciones De Uso

página de 109

/ 109
Contenido
Tabla de contenido
Marcadores

Tabla de contenido

Idiomas disponibles

not in this position, pull the upper cold tip (8) outwards and, at the

same time, turn it 180 degrees to the right (Fig. D) so that they face

inwards. Repeat the step with the lower cold tip (8).

•

Put the top protective cover (9a) back on, resting it about 1 cm from

the attachment base, and slide it down until the 2 hooks fit into their

positions (Fig E).

•

Put the bottom protective cover (9b) back on, resting it about 1 cm

from the attachment base, and slide it down until the 3 hooks fit into

their positions (Fig F).

•

Connect the power cable (5) to the mains.

•

Switch the styler on by sliding the O/I (4) button to the left.

•

Select the desired temperature from the 4 temperatures available

(150°C - 170°C - 190°C - 210°C) by pressing the + or - buttons (3)

•

The styler is ready for use when the temperature on the display (2)

stops flashing

•

To activate the key lock, press and hold the + button for a few

seconds.

•

To create waves: use one hand to pull the lock of hair and, starting

from the roots, insert it between the heated parts (1) with the other,

then close the product and hold it pressed for a few seconds.

Repeat the styling operation along the entire length of the hair.

•

For straight hair: use one hand to pull the lock of hair and with the

other insert it between the heated parts (1), then close the styler

and slide it from the roots to the ends. You can use a comb to do so.

Continue in the same way with each lock of hair.

•

When you have finished styling your hair, switch the appliance off

by sliding the button (4) to the right to O and disconnect it from the

socket.

•

Let the appliance cool completely.

•

Use the specific closing lock (6) to close and store the styler.

o n .