Automatic Switch-Off - Imetec Bellissima Intellisense B24 100 Instrucciones De Uso

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 33
icon corresponding with your hair thickness, press
icon becomes steady on the display and the other two disappear.
If you wish to change your selection press back
the selection.
During heating of the straightener, the range of symbols lights
up in succession and the display changes intensity of the colour
until the temperature for the hair type selected has been reached.
The range is steady. The straightener is ready to use.
If you wish to enable the key lock, press
The padlock
accidental temperature changes while using the straightener. To
disable the key lock, press
Take a thin lock of hair, the same width as the plate and place it
between the two plates.
Keep the lock of hair taut with one hand and, with the other hand,
slide the closed plate from the roots down to the ends.
If you wish to change the hair type selected, press back
once and repeat the selection operations described.
If you wish to select the manual mode press back
and follow the indications in the INSTRUCTIONS FOR USE
paragraph; manual mode.
Switching off the product
Press
(6) for at least two seconds to switch the product off.
Disconnect the straightener from the socket.
NOTE: If the straightener is switched off but is not
disconnected from the socket, the background colour of the
display remains on until a temperature of about 70°C has been
reached; this indicates that the straightener is still hot.
Plate closing system
The straightener has a closing system
To fasten the two arms in the closed position, hold them together
and press the plates lock (7)
To unlock, press the plates lock on the opposite side
NOTE: steam may appear while straightening; this is excess
humidity in the hair evaporating.
NOTE: If the background colour of the display flashes red
or magenta the straightener has a fault. Contact an assistance
centre.
ATTENTION! Risk of scalding

AUTOMATIC SWITCH-OFF

The straightener switches off automatically 1 hour after being
switched on.
appears on the display. This function prevents
(6) twice again quickly.
17
(6). The
(4) and repeat
(6) twice quickly.
(4)
(4) twice
EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

M5001

Tabla de contenido