TFA 60.2544 Instrucciones De Uso página 13

TFA_No. 60.2544_anl_02_18 26.02.2018
CHANGE – Radio-controlled alarm clock
5. Elements
A: Display (Fig. 1):
A 1: Optional display:
– Clock, seconds, weekday
– Humidity, indoor temperature
A 2: Alarm symbol
A 4: Circle symbol for alternating display
A 6: Day of the week
A 8: Battery symbol
A 10: Snooze
B: Buttons (Fig. 2+3):
B 1: SNOOZE/LIGHT sensor button
9:59 Uhr Seite 13
– Date, weekday
– Alarm time
A 3: AM/PM
A 5: DCF reception symbol
A 7: Daylight Saving Time symbol
A 9: Time zone
A 11: Alarm mode
B 2: Dial
– 24 –
CHANGE – Radio-controlled alarm clock
C: Housing (Fig. 2+4):
C 1: Battery compartment
6. Getting started
• Open the battery compartment and insert two new AA 1,5 V batteries. Make sure the polarity is correct.
• Close the battery compartment again.
• The device will alert you with a beep and all segments will be displayed for a short moment.
6. Radio-controlled time reception
• The clock will now scan the DCF frequency signal and the DCF symbol will be flashing on the display. When
the time code is successfully received after 3-7 minutes, the radio-controlled time and the DCF symbol will
be shown steadily on the display.
• If the reception fails, the DCF symbol will disappear and the clock will repeat the reception every 3 hours.
• The DCF reception always takes place at 1:00 in the morning. If the reception is not successfully received,
further attempts will be taken at 2:00, 3:00, 4:00 and 5:00 o'clock.
C 2: Stand (fold out)
– 25 –