Ibiza Light PAR-MINI-UV Manual De Uso página 3

•
The product is for decorative purposes only and not suitable as a household room illumination.
•
The light source of this luminaire is not replaceable. When it reaches the end of its life time, the whole unit
must be discarded.
•
DISCONNECT DEVICE: Where the MAINS plug or an appliance coupler is used as the disconnect device, the
disconnect device shall remain readily operable.
INSTALLATION
The unit should be mounted via its screw holes on the bracket. Always ensure that the unit is firmly fixed to
avoid vibration and slipping while operating. Always ensure that the structure to which you are attaching the unit
is secure and able to support a weight of 10 times of the unit's weight. Also always use a safety cable that can
hold 12 times the weight of the unit when installing the fixture.
The equipment must be fixed by professionals at a place where is out of the reach of people and where nobody
can pass by or under it.
CABLE CONNECTORS
Cabling must have a male XLR connector on one end and a female XLR connector on the other end.
DMX CONNECTOR CONFIGURATION
Termination reduces signal errors. To avoid signal
transmission problems and interference, it is always
advisable to connect a DMX signal terminator.
CAUTION
Do not allow contact between the common and the fixture's chassis ground. Grounding the common can cause
a ground loop, and your fixture may perform erratically. Test cables with an ohm meter to check correct polarity
and to make sure the pins are not grounded or shorted to the shield or each other.
NAVIGATION THROUGH THE CONTROL PANEL
All functions and operations can be controlled manually on display without DMX controller.
Enter into menu by pressing the MENU button and select the menu item via the up and down keys. Press the
ENTER button to confirm your choice. Increase or decrease the value via the UP/DOWN keys. Press ENTER to
confirm and exit the menu..
Button Function
MENU Used to access the menu or to return to a previous menu option
UP Scrolls through menu options in ascending order
DOWN Scrolls through menu options in descending order
ENTER Used to select and store the current menu or option within a menu
LCD DISPLAY
MENU VALUE
D001 001-512
AU 01-32
SO 0 1
0 2
U 001-255
FL 01-32
SET DMX ADDRESS CODE:
1. Enter into the menu by pressing the MENU button. Select d001 via the up and down keys and press ENTER.
Modify the value via the up and down keys. Press ENTER to save and exit, or press the MENU button to exit
without saving.
2. Enter into menu by pressing the MENU button, select among a variety of operating codes via the UP/DOWN
keys. Press ENTER to save and run or MENU to leave the menu and return to the operating modes.
Manual - PAR-MINI-UV
FUNCTION
DMX
Auto Mode, Speed from slow to fast
Sound Mode 1 (Sound ,color change )
Sound Mode 2 (Sound ,Strobe)
Dimmer
Strobe speed (from slow to fast)
www.ibiza-light.com
COMMON
DMX +
INPUT
DMX-
Resistance 120 ohm
1/ 4w between pin 2
(DMX-) and pin 3
(DMX+) of the last
fixture.
8.8.8.8.
MENU UP DOWN ENTER
EN
3