Technical Data And Characteristics; Dimensions And Connections - Ferroli ENERGY TOP W 60 Instrucciones De Uso, Instalación Y Mantenimiento

5. TECHNICAL DATA AND CHARACTERISTICS

Key of figures cap. 5
7 Gas inlet
10 System delivery
11 System return
16 Fan
22 Main burner
29 Fume outlet manifold
32 Heating circulating pump (not supplied)
36 Automatic air vent
38 Flow switch
44 Gas valve
72 Room thermostat (not supplied)
72b Second room thermostat (not supplied)
81 Ignition electrode
82 Detection electrode
95 Diverter valve (not supplied)
A = Heating phase
B = DHW phase
C = Neutral
NOTE: For 2-wire valves with spring return, use connections B and C
98 Switch
114 Water pressure switch
130 DHW circulating pump (not supplied)
138 External probe (not supplied)
139 Remote timer control (not supplied)
154 Condensate drain pipe
155 Hot water tank temperature probe (not supplied)
186 Return sensor
191 Fume temperature sensor
193 Trap
196 Condensate tray
215 Air inlet reducer
220 Ignition card
256 Modulating heating circulating pump signal
278 Double sensor (Safety + Heating)
298 Cascade temperature sensor (not supplied)
299 Input 0-10 Vdc
300 Burner lit contact (voltage-free contact)
301 Fault contact (voltage-free contact)
302 Remote reset input (230 Volt)
306 Heating system circulating pump (not supplied)
307 Heating system second circulating pump (not supplied)
345 Exchanger safety thermostat
EN
ENERGY TOP W 60/70/80/125

5.1 Dimensions and connections

222
84
1
ENERGY TOP W 60/70/80
ENERGY TOP W 125
1 = Heating system delivery - 1" 1/2 F
3 = Gas inlet - 1" M
5 = Heating system return - 1" 1/2 F
B
The output relay of the heating circulating pump (32) has a capacity of
8A@230Vac.
The output relays of the diverter valve (95) have a capacity of 5A@230Vac.
In case of loads with higher absorption, supporting relays with respective addi-
tional protection must be installed.
cod. 3541H150 - Rev. 03 - 04/2018
Ø 80
Ø 80
445
120
278
A 20
3
5
fig. 42 - Dimensions and connections
49
102
440
A
65
63