Toro 117–3600 Manual De Instalación página 4

1. Bolt, (3/8 x 1 inch)
2. Handle assembly
2. Fasten the cables to the machine with a plastic tie
(Figure 4). Ensure the cables do not contact the
rear tire.
1. Handle assembly
Figure 3
3. Right side of machine
Figure 4
2. Plastic cable tie
4
Installing the Handle to a Z
Master ® G3 Mower
Parts needed for this procedure:
1 Handle assembly
2 Bolt, (3/8 x 1 inch)
1 Plastic cable tie
1 Adhesive back mount
Procedure
1. Install the handle assembly to the right side of the
machine with 2 bolts (3/8 x 1 inch) (Figure 5).
1. Bolt, (3/8 x 1 inch)
2. Handle assembly
2. Install the adhesive back plastic mount on a smooth
clean surface. Thread the cable tie through the
plastic mount and secure the cables with the cable
tie (Figure 6).
4
Figure 5
3. Right side of the machine