Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
COOKTOPUSE
Fire Hazard
Do not let the burner flame extend beyond the
edge of the pan.
Turn off all controls when not cooking.
Failure to follow these instructions can result in
death or fire.
Electric ignitors automatically
light the surface burners when
control knobs are turned to LITE.
Before setting a control knob, place filled cookware on the grate.
Do not operate a burner using empty cookware or without
cookware on the grate.
To Set:
1. Push in and turn knob counterclockwise
to LITE.
All four surface burners will click. Only the burner with the
control knob turned to LITE will produce a flame.
2. Turn knob anywhere between HIGH and LOW. The clicking
will stop. Use the following chart as a guide when setting heat
levels.
SETTING
RECOMMENDED
USE
LITE
•
Light the burner.
HI
•
Start food cooking.
•
Bring liquid to a boil.
MED
•
Hold a rapid boil.
•
Quickly brown or sear food.
•
Fry or saute foods.
•
Cook soups, sauces and gravies.
•
Stew or steam foods.
LO
•
Keep food warm.
•
Melt chocolate or butter.
•
Simmer.
Power failure
In case of prolonged power failure, the surface burners can be
lighted manually. Hold a lighted match near a burner and turn
knob counterclockwise
to LITE. After burner lights, turn knob to
setting.
REMEMBER:
When range is in use or (on some
models) during the Self-Cleaning cycle, the entire
cooktop area may become hot.
.............................
1. Burner cap
2. Alignment pins
3. Ignitor
4. Burner
5. Gas tube opening
IMPORTANT:
Do not obstruct the flow of combustion
and
ventilation air around the burner grate edges.
Burner cap: Always keep the burner cap in place when using a
surface burner. A clean burner cap will help prevent poor ignition
and uneven flames. Always clean the burner cap after a spillover
and routinely remove and clean the caps according to the
"General Cleaning" section.
Gas tube opening:
Gas must flow freely throughout
the gas tube
opening for the burner to light properly. Keep this area free of
soil and do not allow spills, food, cleaning
agents or any
other material
to enter the gas tube opening.
Protect it from
spillovers by always using a burner cap.
2
1. 1-1V2" (25-38mm)
2. Bumer ports
Burner ports: Check burner flames occasionally
for proper size
and shape as shown above. A good flame is blue in color, not
yellow. Keep this area free of soil and do not allow spills, food,
cleaning agents or any other material to enter the burner ports.
Publicidad
Tabla de contenido
