Hendi 221204 Manual De Usuario página 5

Thermal protection
This juicer is protected by a built-in thermal cut-out.
In the event of overheating, the motor will stop.
To reset, follow these steps.
• Set the On / Off switch to "Off", and disconnect
the plug
Repair and maintenance
• Repairs may only be done by an authorized service
facility.
• Regularly check the rubber sealing of the drive-
shaft on wear. Replace them in time so acids/juic-
es cannot leak into the motor base.
• Never immerse the motor base in water; wipe with
a damp cloth to clean.
• Always switch off the motor and unplug the appli-
ance when you are not using it, when you remove
or install spare parts or when you clean the ap-
pliance.
Technical data
Operating voltage: 220-240V~ 50/60Hz
Power consumption: 180 W
Protection class: Class I
Technical data is subjected to change without prior noticification.
Warranty
Any defect affecting the functionality of the appli-
ance which becomes apparent within one year after
purchase will be repaired by free repair or replace-
ment provided the appliance has been used and
maintained in accordance with the instructions and
has not been abused or misused in any way. Your
statutory rights are not affected. If the appliance is
claimed under warranty, state where and when it
Discarding & Environment
At the end of the life of the appliance, please dispose
of the appliance according to the regulations and
guidelines applicable at the time.
• Wait until the motor cools (20-45 minutes), recon-
nect the plug, then press the On / Off switch again.
If the problem persists, remove the plug from the
socket, and contact your supplier.
• The appliance is very easy to clean because all the
parts which make contact with the juice are quick-
ly removable: the cone, pip filter, bowl etc. These
parts can also be cleaned in the dishwasher.
• Rinse all parts coming into contact with the juice
immediately after use.
• Take care to wash all parts, which make contact
with the juice before using the appliance for the
first time.
Short time operation: 10 minutes operation / 30 ~ 40
minutes cooling time
was purchased and include proof of purchase (e.g.
receipt).
In line with our policy of continuous product devel-
opment we reserve the right to change the product,
packaging and documentation specifications with-
out notice.
Throw packing materials like plastic and boxes in
the appropriate containers.
EN
5