Vacuum Function; Steam Function - Kruger KGV7000 Manual De Instrucciones

CAUTION: make sure that the tank containing water is correctly positioned (black cap). To
make it easier there is a label indicating "WATER ONLY".
Never reverse the tanks during the filling operation.

3.2 VACUUM FUNCTION

Lift the cover and the sealing element to cover tank (18, Fig. 5) and pour drink water in
the tank (Fig. 8): about 500 cc.
Put the sealing element (18) and the cover back in place.
CAUTION: An electronic system with warning signal prevents the vacuuming function
from activating if there is no or unsufficient water in the compartment of the tank.
The level float gauge inside the tank indicates the water level. In case there is too much water
in the tank, empty it.
CAUTION: It is very important to use the anti-foam product recommended by the
manufaturer in order to prevent the formation of foam in the dirty water basket. The
manufacturer assumes no responsibility for damages resulting from failure to comply with
this requirement and / or use of products other than those recommended.
CAUTION: It is very important to keep clean the dirty water basket clean and its components,
especially the float element. Make sure it is free to slide in and not obstructed in any way,
this may cause malfunction of the level detection in the dirty water basket and can cause
damage to the machine. The manufacturer assumes no responsibility for damages resulting
from failure to comply with this requirement.
CAUTION: when the vacuum function is on, the machine has a sound emission of 76 db.

3.3 STEAM FUNCTION

Unscrew the tank cap (5, Fig. 1.1) and fill it exclusively with drink water. It's strictly forbidden to fill
the boiler's water tank with detergents, perfumes or other chemicals.
All water entering the machine is filtered by a patented magnetic technology that allows limestone to
break the bonds between the molecules that cause the creation of limestone, in this way, although it
is not possible to stop limestone creation, you can limit it. (It is important to remember that this device
does not replace the obligation to provide frequent maintenance, like boiler draining or the use of
anti-limestone product recommended by KS Group that prevents damage caused by the limestone).
Caution: It is absolutely compulsory to add to the water tank, both water and hydrojet, the
anti-limestone product recommended by the manufacturer. The amount to be added for each
liter of water is 2.5 grams, the lack or use of the wrong amount of anti-limestone causes
serious problems that damage the major organs of the cleaner. The manufacturer grants no
warranty for problems resulting from failure / misuse of the product, the use of a different
product and in general from damage caused by limestone.
10